| Stereo Mode (both channels driven) |
Continuous Average Output Power Per Channel |
| 2 ohms EIA 1kHz 1% THD |
2500W |
| 4 ohms EIA 1kHz 0.1% THD |
1800W |
| 8 ohms EIA 1kHz 0.1% THD |
1100W |
| 4 ohms FTC 20Hz-20kHz 0.1% THD |
1600W |
| 8 ohms FTC 20Hz-20kHz 0.1% THD |
1050W |
| Bridge Mono Mode |
Continuous Average Output Power |
| 4 ohms EIA 1kHz 1% THD |
5000W |
| 8 ohms EIA 1kHz 0.1% THD |
3600W |
| 8 ohms FTC 20Hz-20kHz 0.1% THD |
3200W |
| Distortion (SMPTE-IM) |
<0.02% |
| Distortion (Typical) 20Hz-20kHz: 10dB below rated power |
<0.02% |
| Distortion (Typical) 1kHz and below: full ratez power |
<0.02% |
| Frequency Response |
20Hz-20kHz, 8 ohms, LF filter bypassed, +0/-1dB 5Hz to 50kHz, 8ohms, LF filter bypassed, +0/-3 dB |
| Damping Factor |
>250 @ 8 ohms |
| Noise (unweighted) |
100 dB below rated output (20 Hz to 20kHz, 8 ohms load) |
| Input sensitivity |
1.42 Vrms for 1000 watts into 8 ohms |
| Control Front |
AC power switch, Ch1 & Ch2 gain control with 41 detents |
| Control Rear |
12-pole DIP switch featuring high pass filter on/off, high pass filter 30/50Hz, Clip Limiter on/off control for each channel and switches for selecting Stereo, Parallel, or Bridge Mode.Push-button circuit breaker for each channel. Slide switch for Grounding / Floating aa |
| Input Impedance |
20k ohms balanced, 10k ohms unbalanced |
| Cooling |
Dual continuous variable-speed fans, front-to-rear air flow |
| Input Impedance |
20k ohms balanced, 10k ohms unbalanced |
| Indicators |
Power-On: Amber SENPRINI logo; Parallel: Green backlight icon; Bridged: Red backlight icon; CLIP/LIM: Red LED; PROTECT: Yellow LED Green LED for -10dB, -20dB and -40dB Signal Lights |
| Connectors Input |
XLR, 1/4”TRS jacks and barrier strip |
| Connectors Output |
Binding posts and speakon outputs (Ch1 speakon wired for biamp) |
| Protection |
Short circuit, open circuit, thermal, ultrasonic, RF protection. Stable into mismatched loads |
| Load Protection |
on/off muting, DC fault output crowbar |
| Output Circuitry |
Class H Amplifier |
| Power Requirements |
220-240VAC (+/- 10%), 50Hz |
| Circuit Breakers |
two (one for each channel): 230 V : 10 amp |
| Dimensions (WxHxD) |
482 x 150 x 400mm (19″ x 5.9″ x 15.7″) |
| Weight |
30.2kg (66.6bs) |
نقد و بررسیها
هیچ دیدگاهی برای این محصول نوشته نشده است.